Lathem 7500E Operation & User’s Manual

49, 22 45 46 Lathem warrants the hardware products described in this guide against defects in material and workmanship for a period of one year from date of original purchase from Lathem or from an authorized Lathem reseller. The conditions of this warranty and the extent of the respons…

2, This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial envi…

27, 22 23 24 Setting the Auto Break Deduction (continued) Example Elapsed time ----- 8 hours Break duration ----- 60 min. 3 Push the SET button. At that moment, the flashing changes to "Hour". In the case of the example, push the CHANGE button to set at "8"…

33, 22 29 30 Set the "ending date". 6 Next, push the SET button. At that moment, the flashing changes "Year" to "Month". 7 Push the CHANGE button to set at "11" and push the SET button. At that moment, the flashing changes from "Month" t…

16, Lathem 7500E 22 13 This time recorder can operate in one of two modes; Payroll Mode or Job Cost Mode. In Payroll Mode and Job Cost Mode, the recorder prints total elapsed time between IN(Start) and OUT(Stop), and also prints a running total of accumulated time per time card on each l…

24, 22 21 20 Setting the Rounding Special Note Regarding "Punch Rounding" When calculating employee hours, it is a common business practice to round to the nearest quarter or tenth of an hour. The 7500E supports both punch and totals rounding. However, it is important that you …