Lathem AirTime ATX6 Installation & User Manual

28, ATX6 Installation and User Guide Page 24 Synchronizing a LTRX-512 to ATX6 using Sync Relay closure (Program ATX6 Relay closure at 12:00AM) Verify Jumpers are “Open” as shown for Sync Output. To access jumpers see page 3. …

3, Table of Contents: Introduction:............................................................................ 1 Case Design ............................................................................. 2 Installation: .......................................................................…

29, ATX6 Installation and User Guide Page 25 Synchronizing the ATX6 to an External Relay Closure (Program Synchronization “SYN”, verify J7 & J8 are Closed) Verify Jumpers are “Closed” as shown for Sync Input. To access jumpers see page 3. …

7, Lathem AirTime ATX6 ATX6 Installation and User Guide Page 3 1. Choose an appropriate location to install the ATX6 on a wall. a. If you intend to use the ATX-GPS accessory to synchronize the ATX6, then a site should be selected that is within the 25-foot cable limit of the ATX-GPS to a window or skyli…

21, ATX6 Installation and User Guide Page 17 RC Transmit: If RC EMULATION is enabled [Set-Up parameter #15, above, = ‘1’] RC Transmit is selected by pressing and holding RC (SET) for 2 seconds. The ATX6 transmits one (1) RC synchronization signal to all RC-series Wall Clo…

31, ATX6 Installation and User Guide Page 27 Warranty Limited One-Year Limited Warranty Lathem warrants the hardware products described in this guide against defects in material and workmanship for a period of one year from date of original purchase from Lathem or from an authorized …