LeCroy WaveMaster 8 Zi Getting Started Manual

183, Getting Started Manual 922133-00 Rev A 175 Index 2 2.92 mm and 2.4 mm Probe and Cable Connection Interface, 24 A Acquisition, 165 actions, 123 Actions for Trace Buttons, 35, 42 Actions for Trace C1 Buttons, 63 active probe, 26 Annotating Traces, 35 autogrid, 86 Aux Outpu…

12, WaveMaster 8 Zi/Zi-A Oscilloscopes 4 922133-00 Rev A CAUTION. Do not block oscilloscope vents. Always keep the area beneath the oscilloscope clear of paper and other items. The instrument also has internal fan control circuitry that regulates the fan speed based on the ambie…

118, LeCroy WaveMaster 8 Zi WaveMaster 8 Zi/Zi-A Oscilloscopes 110 922133-00 Rev A Using the Param Compare conditions, each Pass/Fail input (Qx) can compare a different parameter result to a user-defined limit (or statistical range) under a different condition. COMPARING A SINGLE PARAMETER 1. With the ParamCompare…

11, Getting Started Manual 922133-00 Rev A 3 Connect and disconnect properly. Do not connect/disconnect probes or test leads while they are connected to a voltage source. Observe all terminal ratings. Do not apply a voltage to any input (C1, C2, C3, C4 or EXT) that exceeds th…

116, WaveMaster 8 Zi/Zi-A Oscilloscopes 108 922133-00 Rev A Use either these checkboxes or the ones on each respective Qx dialog to enable the specific condition for use. When you have each of the Qx dialogs configured and enabled as desired, you can then begin your testing …

105, Getting Started Manual 922133-00 Rev A 97 Help Markers Setup 1. Touch Measure → Measure Setup... on the menu bar. 2. Select a Measure Mode: Std Vertical, Std Horizontal, or My Measure. 3. Touch the Show All button (as follows) to display Help Markers for every parame…