Lexicon LEXICON480LV4 Owner's Manual

113, Bank 15: the Prime Time III Programs 12-3 Page 2 PDL and PDR (Left and Right Predelays) PDL and PDR are predelay lines which are indepen- dently set for left and right. The entire modulation effect takes place within these two delay lines. All feedbacks wrap back to these delay lines. INDL…

93, Bank 10: the Compressor Programs 9-3 ATC (Attack Time Constant) ATC adjusts the speed with which the compressor responds to an increase in input level. The nominal value is about 30ms. The times on the slider move in factors of 2, from 7ms to about 1 second. Both 7ms and 15ms will…

81, Lexicon LEXICON480LV4 Bank 9: the Mastering Programs 8-3 The result of this control is to change the separation of low frequency stereo signals. When the control is raised low frequencies in the sum (mono) channel are reduced, and low frequencies in the difference (stereo) channel are raised. With the control at m…

71, 6-10 Lexicon 480L Owner's Manual HEAD TRIM Once a sample has been recorded, head trim is used to remove unwanted information at the beginning of the sample, selecting a new start point for playback. A fine mode is provided for precise trim. Press the button under the Head Trim slide…

132, A-8 Lexicon 480L Owner's Manual Sysex Message Formats 480 Generic System Exclusive Message Format $F0 System Exclusive ID $06 Lexicon ID $01 480 ID 0ccc nnnn Message Class and Sysex Device ID ccc = Message Class 0-7 nnnn = Channel Device ID 0-15 0sssssss Message Subclass sssssss = S…

124, Bank 17: the Test & Reference Programs 14-4 About the Parameters Page One DRY (Dry Level) Controls the level of the direct sound. The output of this parameter is fed to the direct sound simulator. WET (Reverb Level) Controls the level of the reverberation generated in Machine A. This slid…