Lexmark Dot Matrix Operation & User’s Manual

4, XSane displays garbage characters..........................................................................................................20 Index..........................................................................................................21 Contents 4 …

9, Using scanadf 1 Open a terminal window, and then type scanadf --source=”Multiple Pages” -d [device_name]. Press Enter. 2 Place your document in the ADF or on the scanner glass. 3 From the printer control panel, select your scan job. Using OpenOffice.org Note: You may use Write…

2, Edition notice January 2011 The following paragraph does not apply to any country where such provisions are inconsistent with local law: LEXMARK INTERNATIONAL, INC., PROVIDES THIS PUBLICATION “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED T…

19, Lexmark Dot Matrix Only one page is displayed on the computer Make sure the source is set to Multiple Pages. If using an OpenOffice.org application You may use Writer, Calc, Impress, or Draw only. 1 From an OpenOffice.org application toolbar, do either of the following: • Click Insert > Picture >…

10, 3 Place your document in the ADF or on the scanner glass. 4 From the printer control panel, select your scan job. Using XSane versions earlier than .99 1 From the toolbar, navigate to: Preferences > Setup > select Enhancement tab > Scan Multiple Page 2 From the dialog, click Sc…

12, Adjusting scan settings Adjusting scan settings using XSane or OpenOffice.org Depending on the application, do either of the following to access the scan options: • Using XSane 1 Open a terminal window, and then type xsane. Press Enter 2 From the “device detection” dialog, navigate to: A…