Lexmark MS710 Series Manual 

11, Lexmark Confidential 11 202.03 Paper Jam – con’t • On some early production units, it is possible that the gear on the Fuser Drive Motor has worked its way loose. • Inspect the fuser for any signs of damage and replace if needed. BAD: Fuser Drive motor – GEAR OFF…

13, Lexmark MS710 Series Lexmark Confidential 13 111.21 Service Printhead Error • The printer will post a 111.21 Printhead Error upon boot up or after re-inserting the Toner Cartridge and Imaging Unit inside the printer. • It could be due to the Printhead not getting the required power to start due to fau…

2, Lexmark Confidential 2 Field Awareness Review The following slides contain issues that were seen during product testing and may occur in the field. Please familiarize yourself with each of these issues, as you will be tested on the key concepts at the conclusion of the le…

12, Lexmark Confidential 12 202.03 Paper Jam – con’t • Check the Fuser Drive Gear by spinning it with one finger. – If the gear spins quickly with little resistance: • Replace the Fuser Drive Module. – If the gear spins normally: • Reseat the fuser • Reseat the Fuser Drive…

8, Lexmark Confidential 8 200.05 Paper Jam • This jam means the input sensor did not detect the trailing edge of the media – usually because multiple sheets were picked. • Most jams occur under the Imaging Unit, but can occur in the Fuser. • Multiple sheets can be picked if the …

20, Lexmark Confidential 20 Squeaking, Grinding and/or Clicking Noises • Squeaks (idle rolls, torque limiter), clicks (clutch, feed belt), and intermittent grinding noises (transport drive 1st mesh, clutch) have could be objectionable to a customer. • To resolve the issue, do the followi…