Lexmark MS810n Printing Manual

15, B 5 E X E C A 4 A 5 LT R 4 Prepare the paper or specialty media for loading. • Flex sheets of paper back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges on a level surface. • Hold transparencies by the edges, and then fan them. Straighte…

16, Lexmark MS810n Without an optional staple finisher With an optional staple finisher ABC One‑sided printing ABC One‑sided printing ABC Two‑sided printing Two‑sided printing • If you are loading prepunched paper for use with the staple finisher, then make sure the holes on the long edge of the paper are on…

17, • Load envelopes with the flap side down and on the left of the multipurpose feeder. B 5 EX EC A4 A5 LT R Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, or self‑stick adhesives. These envelopes may severely damage the printer. • Make…

12, Note: If the holes on the long edge of the paper are on the left side of the tray, then a jam may occur. • Make sure the paper is below the maximum paper fill indicator. Warning—Potential Damage: Overfilling the tray can cause paper jams. 5 Insert the tray. Note: Press the paper stack down whi…

10, c Put the A5 length guide in its holder. 2 1 d Squeeze the length guide and slide it to the correct position for the size of the paper being loaded until it clicks into place. Printing Guide Page 10 of 18 …

3, 4 Flex the sheets back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges on a level surface. 5 Load the paper stack with the printable side facedown. Note: Make sure the paper or envelope is loaded properly. • There are different ways o…