Lexmark MX410 Series Operation & User’s Manual

289, Action Yes No Step 9 Check for washed‑out or overexposed output. a From the Copy screen, adjust the settings of the following: • Background Removal—Reduce the current setting. • Darkness—Increase the current setting. b Resend the copy job. Do pages show washed‑out or overexposed p…

95, Lexmark MX410 Series Paper Saver This option lets you print two or more pages of an original document on the same page. Paper Saver is also called N- up printing where N stands for the number of pages. For example, 2-up would print two pages of your document on a single page, and 4-up would print four pages of your d…

36, 9 Slightly close the ISP exterior cover up to 65 degrees, and then slide the cover to attach. 1 2 3 4 10 Run the ISP cable through the controller board shield. Additional printer setup 36 …

238, 3 Reload paper into the multipurpose feeder. Note: Make sure the paper guide lightly rests against the edge of the paper. 4 From the printer control panel, touch to clear the message and continue printing. For non‑touch‑screen printer models, select Next > > Clear t…

248, Memory full, cannot send faxes 1 From the printer control panel, select Continue to clear the message and cancel the fax job. For non‑touch‑screen printer models, press to confirm. 2 Do either of the following: • Reduce the fax resolution, and then resend the fax job. • Re…

198, Use To PCL Emulation Settings Point Size 1.00–1008.00 Change the point size for scalable typographic fonts. Notes: • 12 is the factory default setting. • Point size refers to the height of the characters in the font. One point equals approximately 0.014 of an inch. This can be increas…