Lexmark T65x Quick Reference Manual

1, Lexmark™ T65x Quick Reference Loading paper and specialty media Loading the 250-sheet or 550-sheet tray 1 Pull the tray out. Note: Do not remove trays while a job prints or while Busy appears on the display. Doing so may cause a jam. 2 Squeeze the width guide tab inward as shown, and move the …

2, Loading the 2000-sheet tray 1 Pull the tray out. 2 Pull up and slide the width guide to the correct position for the paper size being loaded. 3 Unlock the length guide. 4 Push the length guide release latch to raise the length guide, slide the guide to the correct position for the paper size b…

3, 6 Load the paper stack: • Print side facedown for single-sided printing • Print side faceup for duplex printing Note: Paper must be loaded differently in the trays if an optional StapleSmart II Finisher is installed. For more information, see the User's Guide/ Note: Notice the maximum fill …

4, Setting the Paper Size and Paper Type The Paper Size setting is determined by the position of the paper guides in the tray for all trays except the multipurpose feeder. The Paper Size setting for the multipurpose feeder must be set manually. The factory default Paper Type setting is…

5, Lexmark T65x 3 Click Other Options, and then click Print and Hold. 4 Select your job type (Confidential, Repeat, Reserve, or Verify), and then assign a user name. For a confidential job, also enter a four-digit PIN. 5 Click OK or Print, and then go to the printer to release the job. 6 From the printer cont…

6, Canceling a print job from the printer control panel If the job is formatting or already printing, and Cancel a job appears on the first line of the display: 1 Press the arrow buttons until Cancel appears. A list of jobs appears. 2 Press the arrow buttons until appears next to the job y…