Teltone M-106E Reference Manual

44, • When returning a unit, ship it to: Can-am Telecommunications Associates Inc. ATTN: write the MRA # here 1845 Sandstone Manor, Unit 11 Pickering, Ontario L1W 3X9 • All fault information available Technical Support For technical assistance with any of the M-106E models, call Telto…

26, • You will hear a voice and tone response in the following format: “one” beep “NN...N” beep beep beep Step 7: Exit programming mode • Enter the disconnect control code (default # #), then hang up. Note: If you do not enter # # before you hang up, the unit will automat…

4, IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions …

47, 3. Unit will not seize the outgoing line A. OUT LED does not light. • Use programming mode to access the unit. • Refer to the programming instructions for the commands. B. OUT LED goes on but you do not hear dial tone. • (Dial tone is provided by the line to which the M-106E …

50, Teltone M-106E Appendix 1: Specifications M-106E Main Board Power requirements (Use only with Class 2 power source, rated 120 VAC, 60 Hz, 10W input; 12 VAC, 500 mA output.) Transformer Input 120 VAC ±10% Transformer Output 12V, 500 mA nominal Ringing voltage detection (unit only detects ringing on …

40, Function 11: Amplifier Sensitivity Setting Sets typical thresholds at which the amplifier turns on. Use this function if problems are experienced with low level signals not being amplified. Function 10, Amplifier Gain Level Setting, must be enabled. (Attempts to use this function with M-106-05E…