Life Fitness SM30 Manual, Unpacking And Assembly Instructions

7, SM30 Unpacking & Assembly Instructions 7 4. Install the weight stacks. To do this: A. Using a 9/16” socket and combination wrench, remove the tricep back rest bolts (see Figure 10). B. Using a 9/16” socket and combination wrench, unbolt the top plate and remove the guide rods (see Figur…

4, SM30 Unpacking & Assembly Instructions 4 ASSEMBLY Figure 2 shows an assembled SM30. Figure 2. SM30 main components (seats and cables removed for clarity). 1. Cube 2. Lat bench 3. Lat top 4. Tricep top 5. Adj. X-over top 6. 150 lb. Weight stacks (2) 7. 300 lb. Weight stacks (1) …

14, SM30 Unpacking & Assembly Instructions 14 Bolt the cable to the weight stacks as shown in Figure 17. Thread the 7/8” nut up on the cable bolt as shown at left. Screw the bolt down into the weight stack as shown at right. Tighten the bolt with a 7/8” combination wrench. Figure 17.…

2, SM30 Unpacking & Assembly Instructions 2 The SM30 comes partially assembled. Follow the steps below to complete the assembly. WARNING: COMPONENTS OF THE SM30 ARE LARGE AND HEAVY. USE CAUTION WHEN ASSEMBLING THIS MACHINE. MATERIALS AND TOOLS REQUIRED FOR ASSEMBLY 1/2”, 3/8”, 5/8” &…

12, Life Fitness SM30 SM30 Unpacking & Assembly Instructions 12 ADJUSTABLE CROSSOVER CABLE ROUTING Once you’ve removed the pulleys as described previously, route the crossover cable as shown in Figure 14. Figure 14. Adjustable crossover cable routing. …

9, SM30 Unpacking & Assembly Instructions 9 6. Mount adjustable pulley bracket. When shipped, the adjustable pulley bracket looks like the one shown in Figure 10. The bolts need to be removed and the bracket needs to be positioned so that the top of the bracket is in the top hole as shown by the …