Light & Motion VX2000 Operation & User’s Manual

3, Light & Motion VX2000 5 Quick Start Guide Every Light & Motion housing is pressure tested prior to shipping. However, unseen damage may have occurred during shipping. It is strongly recommended to test dive with only the housing prior to installing the camcorder. 1) Attach a fully charged Sony NP-…

11, 2120 Assembly with Universal Mounts Mounting Arm to Light Heads Align top of arm with arm light head base and press FIRML Y together. Arm should snap into position. (ref. fig. 25). Removing Arm from Light Heads To remove light head from arm, “break” the arm at the upper most jo…

12, 2322 Light Operation Before you turn on the Pro lights, verify that the mode selector (flat position of black ring around red power button) is set to the P setting. Before you turn on the Elite lights, verify that the mode selector (flat position of black ri…

7, Housing Storage Store housing and Travel Case in a dry location. 24 hours after a dive, leave the Rear Plate off the housing to allow for air circulation. Similarly, leave Travel Case Lid about two inches open. Allow any residual water to evaporate from the Travel Case prior …

9, Bluefin VX2000 Lights - Getting Started Pictured below are the components of both the SunRay -X Pro and the SunRay -X Elite lighting systems. Take a moment to familiarize yourself with each part for later identification and use. Battery Pods Pro light heads Charger and electric…