Linear EXA-2000 Manual, Installation Instructions

Manual, Installation Instructions for Linear EXA-2000 Radio Antenna (1 pages)

Specifications:

533/533197-exa2000.pdf file (15 Oct 2023)
  • Manufacturer: Linear
  • Category of Device: Radio Antenna
  • Document: EXA-2000, File Type: PDF Installation Instructions
  • Updated: 15-10-2023
  • Count of Pages: 1
Download EXA-2000 Manual (1 pages)

Read PDF Document Online:

Data: UPD 15th October 2023

Linear EXA-2000 Radio Antenna PDF Installation Instructions (Updated: Sunday 15th of October 2023 01:42:33 PM)

Rating: 4.7 (rated by 56 users)

Compatible devices: KH 2329, FM Tower 17, LFA-440M10EL, TRK-SR1, AN-75DAB, RSX150G, HPBA-2510, LPA500.

Recommended Documentation:

Text Version of Linear EXA-2000 Radio Antenna Manual (Summary of Contents)

(Ocr-Read of Document's Main Page, UPD: 15 October 2023)


EXA-2000
Remote Antenna
Installation
Instructions
(619) 438-7000 • FAX (619) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
The EXA-2000 Remote Antenna is designed to enhance the radio range of Linear’s
receivers. This antenna can be connected to the “F” connector on many Linear
receivers to improve their range when they must be located in poor signal reception
locations. Usually an increase of 20-30% range can be expected. The versatile
EXA-2000 can be mounted either vertically or horizontally.
✶ NOTE: Generally, the higher the antenna is mounted above ground level,
the better the radio range will be.
The EXA-2000 provides maximum performance when mounted and installed
properly according to these instructions. Please read the entire instructions
before beginning any work. The EXA-2000 is a 1/2 wave, center fed, antenna
composed of two parts: an antenna assembly with a ten-foot, 75-ohm coaxial cable
with an “F” connector and two mounting brackets. The cable connects to the “F”
connector on the receivers.  If the antenna must be mounted further than ten feet
from the receiver, an additional extension cable of 15 feet may be used for a
maximum cable run of 25 feet.  Because of the cable resistance, the performance
of the EXA-2000 may be degraded by using more than  25 feet of cable.
STEP 1
 
Identify Parts.
   Lay out and identify the parts as shown.
Check to be sure all items were included in the kit.
STEP 2 
Determine mounting location. Refer to the antenna
patterns shown to determing mounting location.
STEP 3
Attach mounting brackets. 
Snap the mounting brackets
onto antenna as shown. Attaching the brackets in opposite directions
improves stability of the antenna mounting.
STEP 4
Wall Mounting
. Mount the EXA-2000 on the wall high
enough to achieve optimum range. Mount to wall using the two #8
screws provided.
STEP 5
  
Post Mounting (Vertical). 
The EXA-2000 can be
mounted vertically by attaching to a post as shown.
STEP 6
 
Attic Mounting.
 Attach the antenna to a joist, beam or
some other object in the attic. Try to keep the antenna as far away from
large metal objects (duct work, furnace vents, etc) as possible. 
Caution: In attics, or under room structures, metal foil back insulation
and drywall metalic vapor barriers will degrade radio range and
performance. 
 
LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship for twelve (12) months. The
Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers
who buy direct from Linear or through Linear’s normal distribution channels. 
Linear does not warrant this
product to consumers. 
Consumers should inquire from their selling dealer as to the nature of the dealer’s
warranty, if any. 
There are no obligations or liabilities on the part of Linear Corporation for
consequential damages arising out of or in connection with use or performance of this product or
other indirect damages with respect to loss of property, revenue, or profit, or cost of removal,
installation, or reinstallation. 
All implied warranties, including implied warranties for merchantability and
implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. 
This
Linear Corporation Warranty is in lieu of all other warranties express or implied.
For warranty service on Linear equipment return product, at sender’s expense to: Linear Corp. Repairs
Dept., 2580 Pioneer Avenue, Suite C, Vista, CA 92083
Linear radio controls provide a reliable communications link and fill an important need in portable wireless
signalling. However, there are some limitations which must be observed.
✶
For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part
15 devices. As such, they have limited transmitter power and therefore limited range.
✶
A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio
signals that occur on or near their operating frequencies, regardless of code settings. 
✶
Changes or modifications to the device may void FCC compliance.
✶
Infrequently used radio links should be tested regularly to protect against undetected interference or
fault.
✶
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor
or dealer, and these facts should be communicated to the ultimate users.
Copyright © 1995 Linear Corporation 211778 A 
ANTENNA
BRACKETS (2)
#8 SCREWS (2)

ATTACH ANTENNA TO 
WALL AS SHOWN  

ATTACH ANTENNA
TO POST AS SHOWN
TOP VIEW
MINIMAL RECEPTION
MAXIMUM
RECEPTION
MAXIMUM
RECEPTION
ANTENNA
MOUNTED
AS HIGH
AS POSSIBLE
CO-AX TO
RECEIVER
HORIZONTAL MOUNT
VERTICAL MOUNT
ANTENNA
MOUNTED
AS HIGH
AS POSSIBLE
CO-AX TO
RECEIVER
PLACE BRACKET
OVER ANTENNA
AND SNAP SHUT
NOTE: FOR ADDED
STABILITY, ATTACH
SECOND BRACKET
WITH MOUNTING HOLE
ON OPPOSITE SIDE




DOC-6ee655a9:

Recommended:
300/SC, MX3000INST, 203721GS, WorkCentre Pro 255

HFp Vertical, 376C, 376C, Rlink, P5 PTP
  • 15-2156OutdoorHDTV AntennaAssemble the entire antenna on the ground.1. Use the supplied hardware to assemble the two main boom sections, as shown. If necessary, lift one end of the main boom so the crossover wires reach the threaded posts.Note: To access slots or holes during assembly, move t ...

    Model & Doc Type: VU-190XR 2

  • Data Sheet 1101 Cypress Creek Road  Cedar Park, Texas 78613, USA  1-512-258-9478  FAX 1-512-258-0740 P PRODUCTS HPBA-2510 High Power Broadband Antenna Product Overview Ultra Wide Range The TDK HPBA-2510 High Power Broadband Antenna provides extremely high field strengths over t ...

    Model & Doc Type: HPBA-2510 2

  • PWR-4CROSS 10m/6m/2m/70cm FM Mobile Antenna Specifications Gain 2.15 dBi (10m, 6m, 2m) 5.5 dBi (430MHz) Power 60W FM Impedance 50 Ω Connector PL-259 V.S.W.RLess than 1.5 Length 123cm Weight 487gr Grounding Required Notes for Using the Antenna To use your antenna PWR-4CROSS by Komunica® pro ...

    Model & Doc Type: PWR-4CROSS 2

  • Garantía Limitada de 12 Meses Audiovox Electronics Corporation (la “Compañia”) le garantiza a usted, el comprador original de este producto que si, bajo condiciones y uso normales, se encontrara que este producto o alguna pieza presenta defectos materiales o de mano de obra dent ...

    Model & Doc Type: ANT3038XR 8

Additional Information:
# Brand Model Document Type/File Pages File Size Last Checked
1 AvaLAN
AW5800XTP
8 28/02
2 Garmin
376C
2 0.89 Mb 30/01
3 Pixel
AFXSM-5
14 21/01
4 TERK Technologies
SIR6
8 20/12
5 EBENCH
KH 2329
9 16/12
6 Electro-Voice
LPA500
7 0.4 Mb 15/11
7 Fujitsu
Stylistic 3400
1 0.03 Mb 02/12
8 Vision Plus
Status 530
2 22/02
9 RCA
ANT3038XR
1 0.46 Mb 22/10
10 Airspan
AirSpeed 1050 Series
50 22/11

Popular Right Now:

# Brand Model Document (PDF) Pages Size Check Date
1 Brother
DCP-165C
112 4.45 Mb 07.02.2024
2 LOVATO ELECTRIC
VLB Series
78 14.12.2023
3 Standard Horizon
GX1246S
13 0.56 Mb 09.04.2024
4 Cisco
8811
128 14.03.2024
5 GE
GHDS830EDWS
54 19.10.2023
6 Stelpro
CH series
4 11.11.2023
7 Uniden
EXP7900
12 05.11.2023
8 Yealink
Yealink SIP-T48G
170 9.43 Mb 05.11.2023
9 Lenovo
ThinkPad Edge E435
180 12.11.2023
10 Electrovision
E304CE
2 29.10.2023
Operating Impressions, Questions and Answers: