Lionel AMC/ARC Log Loader Owner's Manual

5, Operating the Log Loader with the controller T he Log Loader has three different functions that can be operated using a controller lever. The controller levers are illustrated in Figure 3. The LED will illuminate each time you operate a lever. • Use the chain drive lever to act…

3, Placing the Log Loader on your layout T he Log Loader is designed for use with remote-control log dump cars (available separately). Position a log dump car over the magnetic disk on a remote-control track section (available separately, 6-65530 for O gauge, 6-65149 or 6-12746 for O-27 gauge, and 6-…

4, Lionel AMC/ARC Log Loader Connecting the power supply Y our Log Loader was designed to operate at 16-18 volts (AC). The power supply terminals are located along the side of the controller. Refer to Figure 2. Please note that the ends of the wires must be stripped back 1/8” to 1/4”. Only an adult should perform this tas…

6, Connecting the Log Loader for operation in the TrainMaster Command Control environment T o operate the Log Loader using your CAB-1 Remote Controller (available separately, 6-12868), you must connect the Crane to the Command Base (available separately, 6-12911). The Command Base w…

2, C ongratulations on your purchase of the Lionel AMC/ARC Log Loader! This accessory incorporates two of the most sophisticated TrainMaster Command Control components, the Accessory Motor Controller and the Action Recorder Controller, which are pre-installed for simple set-up. In the Command Cont…