LSI LSI53C810A Technical Manual

70, LSI LSI53C810A 4-8 Signal Descriptions 4.1.4 Arbitration Signals Table 4.5 describes the Arbitration Signals group. 4.1.5 Error Reporting Signals Table 4.6 describes the Error Reporting Signals group. Table 4.5 Arbitration Signals Name Pin No. Type Strength Description REQ/ 200, A4 O 16 mA PCI Request indicates…

216, 7-34 Electrical Characteristics Figure 7.24 100 LD PQFP (UD) Mechanical Drawing (Sheet 1 of 2) Important: This drawing may not be the latest version. For board layout and manufacturing, obtain the most recent engineering drawings from your LSI Logic marketing representative by req…

104, 5-30 Operating Registers Register: 0x19 (0x99) Chip Test One (CTEST1) Read Only FMT[3:0] Byte Empty in DMA FIFO [7:4] These bits identify the bottom bytes in the DMA FIFO that are empty. Each bit corresponds to a byte lane in the DMA FIFO. For example, if byte lane three is empty, then F…

17, LSI53C810A Benefits Summary 1-5 • Three programmable SCSI timers: Select/Reselect, Handshake-to- Handshake, and General Purpose. The time-out period is programmable from 100 µs to greater than 1.6 seconds • SDMS software for complete PC-based operating system support • Supp…

233, U.S. Distributors by State A. E. Avnet Electronics http://www.hh.avnet.com B. M. Bell Microproducts, Inc. (for HAB’s) http://www.bellmicro.com I. E. Insight Electronics http://www.insight-electronics.com W. E. Wyle Electronics http://www.wyle.com Alabama Daphne I. E. Tel: 334.626.619…

194, 7-12 Electrical Characteristics 7.4 PCI Interface Timing Diagrams Figure 7.9 through Figure 7.18 represent signal activity when the LSI53C810A accesses the PCI bus. The timings for the PCI bus interface are listed on page 7-26. The following timing diagrams are included in this section: …