Data: UPD 22nd February 2024
Manitowoc K00197 Ice Maker PDF Installation Instructions (Updated: Thursday 22nd of February 2024 09:20:59 AM)
Rating: 4.9 (rated by 3 users)
Compatible devices: TIMER GSI 200, K000187, K00142, ICE DEFLECTOR K00382, MFD-50, K00106, SN20, Q450.
Recommended Documentation:
Text Version of Manitowoc K00197 Ice Maker Manual (Summary of Contents)
(Ocr-Read of Document's Main Page, UPD: 22 February 2024)
K00197 ADAPTER KIT
Installation Instructions
The K00197 kit is used for installing a Q-0320, Q-0420, QC0700, QF0800, and 22" S-series ice machines on a Manitowoc S-970 bin.
1. Note: Bin must be level before installation of ice machine.
A. Remove the foam tape from the front and sides of the bin where the support angle will be located. Use the front angle to
reference the areas where the tape should be removed.
B. Place the support angle on the front edge of the bin and position as far forward as possible.
C. Locate the four pieces of the 2” long, 3/4” wide foam tape in the front corners, as shown.
D. Place the adapters on the bin, as shown. Make sure the two holes from the support angle and adapters are aligned on the
side.
E. Using the adapters as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in bin.
Warning! Do not drill through the interior liner. Attach each adapter with three #10-24 x .500” screws provided.
F. Apply foam tape to the front and back of the bin between the adapters.
G. Note: It is recommended to RTV the tape intersections and along the inside of the foam tape to prevent water tracking.
2. Refer to ice machine installation manual for ice machine installation procedures.
Manitowoc Ice, Inc.
2110 South 26
th
Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 8005993
Web Site - www.manitowocice.com Rev. 05/12/04
#10-24 x .500”
Screws
Two Pieces of Wide Foam Tape in each
Corner, under Adapters, Located as Shown in
Detail View Below
Wide Foam Tape
Adapters
Adapter
Adapter
Wide Foam Tape
Two Pieces of
Wide Foam Tape
Foam Tape
Under Adapter
Recommended:
BatteryFREE NB-72D, RDX RDX 500GB, Ultra MAC 2000 Series, CDE-136BT
DM-180A6, SP 18, AJ000522, GI1500XH, U-3018CLRS-00A
-
Portable Ice Maker General Information AFTER SALES SUPPORT 1 888-367-7373 ...
Model & Doc Type: HZB-12/A 28
-
HISUBR/UBR/UBR SELFCONTAINEDCUBEICEMAKERHISUBR/UBR/UBRSELFCONTAINEDCUBEICEMAKERIce. Pure and SimpleIce Maker WarrantyEvery Ice-O-Matic ice maker is backed by a warranty that provides both pa ...
Model & Doc Type: HISU056BR 2
-
IMPORTANT:TO THE INSTALLER.It is the responsibility ofthe Installer to ensure thatthe water supply to thedispensing equipment isprovided with protectionagainst backflow by an airgap as defined inANSI/ASME A112.1.2-1979;or an approved vacuumbreaker or other suchmethod as proved effectiveby test.Wate ...
Model & Doc Type: Enduro 200 20
-
© SUB-ZERO PLANNING GUIDE 2006 (REV 2.0) 1MODEL 315I(P)Model 315I(P)ICE MAKERLarge ice storagecapacityWater reservoirAutomatic ice makerIce scoopReversible doorhingeFront venting withremovable kickplateSerial and modelnumber plateFour-sidedmagnetic gasketMODEL 315I(P)Undercounter ...
Model & Doc Type: 315I 5
Operating Impressions, Questions and Answers:
