Maretron MBB100 Operation & User’s Manual

3, Revision 1.0 Page iii ®® Table of Contents 1 General .......................................................................................................................................... 1 1.1 Introduction .....................................................…

10, Maretron MBB100 MBB100 User’s Manual Step 3: Once aligned, gently insert the serial cable RS-232 connector into the MBB100 RS-232 connector. 2.4.2 VGA Connection There is one external VGA connector. The VGA connector enables connection to an monitor. To connect a VGA cable with th…

22, MBB100 User’s Manual Page 18 Revision 1.0 7 Technical Support If you require technical support for Maretron products, you can reach us in any of the following ways: Telephone: 1-866-550-9100 Fax: 1-602-861-1777 E-mail: [email protected] World Wide Web: http://…

9, ®® Figure 4 - MBB100 Rear Panel Connections The I/O interface panel located on the front of the MBB100 (see Figure 5) has two USB 2.0 interface connectors. Figure 5 – MBB100 Front Panel 2.4.1 RS-232 Connection There is one external RS-232 connect…

13, ®® Alternatively, you may Enter Demo Mode. In Demo Mode, you will not be able to connect to a Server and view live data; instead simulated data will be provided to stimulate the controls. The first time you start the MBB100, you must ensure that the device can connect to your …

11, ®® 2.4.4 USB Device Connection There are four external USB 2.0 connectors. To connect a USB 2.0 or USB 1.1 device, please follow the instructions below. Step 1: The locations of the USB connectors are shown in and Figure 5. Step 2: Align the USB device connector w…