Maretron J2K100 Operation & User’s Manual

30, Maretron J2K100 J2K100 User’s Manual This configuration requires two additional drops or stubs from the J1939 trunk or backbone to the Maretron J2K100s. You should follow the engine/genset manufacturer’s instructions for adding the drop, which are generally specified to be 1 meter or less in length. …

22, J2K100 User’s Manual Page B2 Appendix B – Application Note Revision 1.1 Table of Contents 1 Introduction ....................................................................................................................... B3 2 NMEA 2000 ® Network Basics .........…

29, ®® Revision 1.1 Appendix B – Application Note Page B9 cable. The network wiring actually requires three wires, two CAN bus signals (usually designated CAN-H and CAN-L, usually yellow and green respectively) and a ground used as a reference (usually designated as…

31, ®® Revision 1.1 Appendix B – Application Note Page B11 This configuration requires two additional drops or stubs from the J1939 trunk or backbone to the Maretron J2K100s. You should follow the engine/genset manufacturer’s instructions for adding the dro…

10, J2K100 User’s Manual Page 6 Revision 1.1 detects incoming messages from the J1939 network and translates them into corresponding NMEA 2000 ® PGNs. For example, if the J2K100 receives engine-related messages from the J1939 network but no transmission or genset messages, then t…

14, J2K100 User’s Manual Page 10 Revision 1.1 Electrical Parameter Value Comment Operating Voltage 9 to 16 Volts DC Voltage Power Consumption <150mA Average Current Drain Load Equivalence Number (LEN) 3 NMEA 2000 ® Spec. (1LEN = 50 mA) Reverse Battery Protection Yes …