Maretron DSM250 Operation & User’s Manual

190, Maretron DSM250 DSM250 User’s Manual 8.3.7.11.1 Trigger Configuration – Direction Alert Figure 198 – Trigger Configuration - Direction Alert Re-trigger Period – When you accept an alert, it will change to the “Accepted” state, and annunciators that are sounding for that ale…

53, ®® Revision 1.4.2 Page 39 data item, but may include any of the following (see Section 7 for descriptions of the available display types). • Anchor Watch ( See Section 7.1 on page 149) • Compass Rose (see Section 7.2 on page 149) • Gauge (see Section 7.3 on…

148, DSM250 User’s Manual Figure 146 – Rectangular Tank Selection The following screen will be displayed. Figure 147- Rectangular Tank Calibration Enter the distance from the face of the TLM100 sensor to the bottom of the tank for the Empty Tank Depth, and the distance from…

163, ®® 7 Data Display Types 7.1 Anchor Watch Display The Anchor Watch Display is a graphical representation of an Anchor Alert. See section 8.3.7.9 for details on how to set up the Anchor Alert. Figure 166 – Anchor Watch Display Example The display is centered on…

157, ®® 6.21.1.2 Instance - Humidity This entry allows you to program the NMEA 2000 device instance for the humidity transmitted in PGN 130313. You usually will not need to modify the default value of “0” unless you have multiple humidity sensors on the network. 6.21.1.3 Instan…

191, ®® 8.3.7.12.1 Trigger Configuration – Time Alert Figure 199 - Alert Editor - Time Alert Alert Time – The alert will become active at the time specified in this field. If the time specified has already passed, then the alarm will be set for the next day. Entering a numb…