Maretron Run Indicator Module RIM100 Operation & User’s Manual

14, RIM100 User's Manual Page 10 Revision 1.0 Environmental Parameter Value IEC 60945 Classification Exposed Degree of Protection IP64 Operating Temperature -25°C to 55°C Storage Temperature -40°C to 70°C Relative Humidity 93%RH @40° per IEC60945-8.2 Vibration 2-…

5, Revision 1.0 Page 1 ®® 1 Introduction Congratulations on your purchase of the Maretron Run Indicator Module (RIM100). Maretron has designed and built your RIM100 to the highest standards for years of dependable and accurate service. Maretron’s RIM100 monitors bo…

17, Revision 1.0 Appendix A – NMEA 2000 Interfacing Page A1 ®® Appendix A – NMEA 2000 ® Interfacing RIM100 NMEA 2000 ® Periodic Data Transmitted PGNs PGN 127501 – Binary Switch Bank Status The RIM100 uses this PGN to transmit the state of each of the connecte…

11, Revision 1.0 Page 7 ®® 2.5.2 Channel #1 - #6 Mode You must configure the RIM100 as to whether a particular channel should be enabled. The allowable values for this parameter are as follows: • “Enable” (default) – Use this value if the channel is being used to mo…

6, Maretron Run Indicator Module RIM100 RIM100 User's Manual Page 2 Revision 1.0 3. Mount the RIM100 (Section 2.3) 4. Connect the RIM100 (Section 2.4) 5. Configure the RIM100 (Section 2.5) 2 Installation 2.1 Unpacking the Box When unpacking the box containing the Maretron RIM100, you shoul…