MATLAB TARGET SUPPORT PACKAGE 4 - FOR USE WITH ANALOG DEVICES BLACKFIN Reference Manual

6, 1 Getting Started System Requirements For detailed information about the software and hardware required to use Target Support Package™ software, refer to the T arget Support Package system requirem ents areas on the MathWorks Web site: • Requirements for Target Support Package: www.m…

18, MATLAB TARGET SUPPORT PACKAGE 4 - FOR USE WITH ANALOG DEVICES BLACKFIN Blackfin537 bf537_uart_rx UART port Select which UART port from which this block receives data. Data length Set the data length, in bytes, of the Out port. This block always outputs the number of bytes the Data length parameter specifies. Enable blocking mode When you enable blocki…

12, Blackfin537 bf537_dac Purpose Convert a stream of digital data to an analog signal and send it to the output jack Library ADSP-BF537 EZ-K IT Lite Description Configure AD1854 audio DAC on ADI BF537 EZ-KIT Lite board to capture audio stream from the Line In jack of BF537 board. This block us…

14, Blackfin537 bf537_uart_config Purpose Configure UART transceiver to capture data from UART port Library ADSP-BF537 EZ-K IT Lite Description Configure UART transceiver on ADI BF537 based board to capture data stream from the U ART port of BF537 board. Your model can only contain one configuration b…

13, Blackfin537 bf537_dac References ADSP-BF537 EZ-KIT Lite® Evaluation System Manual, Part Number 82-000865-01, available from the Analog Devices Web site. See Also Blackfin537 bf537_adc 3-5 …

17, Blackfin537 bf537_uart_rx Purpose Receive data stream from U ART port Library ADSP-BF537 EZ-K IT Lite Description Configure UART receiving on ADI BF537-based board to receive data stream from the UART port on the board. This block outputs [Nx1], where N indicates the data length in an ar…