Meyer Sound 500-HP Operating Instructions Manual

12, CHAPTER 2: POWER REQUIREMENTS 12 The AC Loop Output Connector (Gray) The gray AC Loop Output connector allows multiple 500-HP subwoofers to be looped and powered from a single power source. Connect the AC Loop Output of the first 500-HP to the AC Input of the second 500-HP, and so …

13, 500-HP OPERATING INSTRUCTIONS 13 CAUTION: The power source for the 500-HP should always operate within the required volt- age range, at least a few volts from the upper and lower ranges. This will ensure that AC voltage varia- tions from the service entry — or peak voltage dro…

15, 15 CHAPTER 3: AMPLIFICATION AND AUDIO The low-frequency drivers in the 500-HP are powered by a two-channel proprietary Meyer Sound amplifier with MOSFET output stages. The audio signal is processed with an elec- tronic crossover, correction filters for phase and frequency response, and dri…

8, Meyer Sound 500-HP CHAPTER 1: INTRODUCTION 8 allows the subwoofer to be easily paired with UltraSeries™ loudspeakers. Also included with all 500-HPs are durable plastic bottom skids that protect the enclosure and align with its top slots for secure stacking. The 500-HP boasts an operating freque…

31, 500-HP OPERATING INSTRUCTIONS 31 Safety Guidelines for Using the MCF-500 Caster Frame ■ Do not stack more than three 500-HPs. ■ When transporting stacks, use straps to secure the 500-HPs, especially if the cabinets are not fitted with the MRF-500 rigging frames. ■ When transporting 500-…