MicroNet mn100 Operation & User’s Manual

18, mn100 Dual Digital Display 16 (p32) Target Page Produces a “Trim” indication showing an increase or decrease in value from a set point. First select the appropriate chapter in the upper display using the button then select “Lock” in the lower display usin…

11, MicroNet mn100 mn100 Dual Digital Display 28 4.3 Wind Calibration Both Wind Speed and Direction can be calibrated to ensure that readings from the Wind Transmitter are displayed accurately. 4.3.1 Wind Angle Offset Motor the vessel directly into the wind. Press and hold the button for 2 sec…

5, mn100 Dual Digital Display 32 5.4 Surface Mounting 5.4.1 Where there is no access to the rear of the mounting surface Easy installation but will allow removal without gaining access to the boat. Position the supplied Template carefully before starting. 1. Drill three 2mm holes ma…

20, mn100 Dual Digital Display 18 3 - Setup and Calibration 3.1 Entering Setup and Calibration Mode To enter the Setup and Calibration menu press and hold for 2 seconds the button. This will not work when in the Race Timer page. 3.2 Chapter and Page Setup and Calibration…

34, mn100 Dual Digital Display 32 5.4 Surface Mounting 5.4.1 Where there is no access to the rear of the mounting surface Easy installation but will allow removal without gaining access to the boat. Position the supplied Template carefully before starting. 1. Drill three 2mm holes…

28, mn100 Dual Digital Display 26 4 - Seatrial and Calibration Once the Micronet Instrument system has been installed on the vessel and Auto Networking has been completed it is necessary to carry out Calibration. It is not safe to use the instruments for navigational purposes u…