MicroNet SP3367A Operation & User’s Manual

49, 48 4.6.2 Time Zone Go to Maintenance Æ Time Zone and select system time for your area. Connecting to a Simple Network Time Protocol (SNTP) server allows the router to synchronize the system clock to the global Internet. The synchronized clock in the router is used to…

39, 38 DMZ Setting Go to Advanced Setup Æ NAT Æ DMZ to set DMZ parameters. If you have a local client PC that cannot run an Internet application properly behind the NAT firewall, you can open the client up to unrestricted two-way Internet access by defining a virtual DMZ Host. …

33, MicroNet SP3367A 32 DNS Go to Interface Æ LAN to enable DHCP server. Then you can set DNS server for the router. A Domain Name system (DNS) server is like an index of IP addresses and Web addresses. If you type a Web address into you browser, a DNS server will find that name in its index an…

68, 67 bridge itself; the bridge is thus transparent to the communicating workstations. It involves frame forwarding, learning workstation addresses and ensuring no topology loops exist (in conjunction with the Spanning-Tree algorithm). UDP User Datagram Protocol - A connectionles…

61, 60 7. Initialization of the ADSL connection failed. STEPS CORRECTIVE ACTION 1 Check the cable connections between the ADSL port and the wall jack. The ADSL LED on the rear panel of the router should be on. 2 Check VPI, VCI, type of encapsulation and type of multiplexing se…

22, 21 4.2 Quick Setup You can use Quick Setup to setup the router as follows, and the router will connect to the Internet via ADSL line. Click Quick Start to get into the quick setup procedures. …