Microtek 710S Operation & User’s Manual

9, 4 Operations User Controls On/Off Power Button Auto-adjustment, Brightness, Menu/Enter and & button On Screen Display, Contrast, Brightness Adjustment, H-position, V-position, Color temperature, Auto Adjustment Control Type: Digital OSD (On-Screen-Display) Compatibility: IBM and co…

20, 15 4. If the PC does not function with the CRT monitor, check the BIOS to see if there is a dual scan setting under the display mode item. Set the BIOS display mode to Dual Scan or CRT and try again. If there is still no display, then there may be a problem with your system. Contact tech…

13, Microtek 710S 8 1. : Power switch Use the power switch to turn power ON or OFF. We recommend turning your system power on first before turning on the monitor. 2. & : Up and Down These two keys are used to move the cursor up or down. These two keys are also used to increase or decrease valu…

7, 2 Factory-preset Modes Table 1 shows standard video mode setting that has been pre-adjusted at the factory for accurate video display. These settings are stored in the monitor’s memory. Table 1. Factory-preset Modes Mode NEC VGA SVGA XGA SXGA Macintosh Resolution 640 x 400 640 x 350 72…

2, ii Table of Contents FCC Compliance Statement .................................................................... ii Introduction ..............................................................................................1 Factory-preset Modes .......................................…

18, 13 DOS Txt/GFX This allows you to select the display mode as 640x400 (graphic mode), or as 720x400 (text mode). Color Temperature Three modes are provided: user mode, 6500, and 9300. Move the cursor key to the color temperature item through the & key, then press the to sw…