Minolta EP6000 Operator's Manual

10, Minolta EP6000 Page Organization Index: Used to locate your chapter quickly. Note: Calls your attention to a particular point in the procedure. Section title Page number Indicates that there are more steps to follow in the next column. Indicates that this is the end of the steps. Chapter title Useful Tip: Gives yo…

48, 4. Starting the Copy Cycle Starting the Copy Cycle The message now changes to "Now copying." and the copier starts the copy cycle. Note: In a multi-copy cycle, the number on the Display is decreased by 1 each time a copy is fed out of the copier. Start Stop 1134P337CA Ready to copy. 20 113…

37, Energy Saver Mode If the copier is shut down when it is not in use, it takes the copier a maximum of 2 minutes and 30 seconds to complete the warm-up cycle. Instead of turning the copier OFF, it’s a good idea to use the Energy Saver mode. This mode will minimize the time it takes the copier to c…

50, 6. Manual Bypass Copying Use the Manual Bypass to make copies on paper not loaded in any Drawer, or to copy onto transparencies, translucent paper, or any other special paper. You can also use the Cover mode when the Multi Bypass Table is used with Duplexing Document Feeder AFR-9 (option). ➭ …

7, Chapter 6 Troubleshooting 153 1. When this Type of Copy is Produced • The Image is too Light 154 • The Image is too Dark 154 • The Copy is Blurry 154 • The Copy has dark specks or spots 155 • The Edge of the Copy is dirty. 155 • The Image on the Copy is not aligned…

125, Check the settings made on the Job Check screen, then touch Recall . 3 1134P360CA Job Check Auto Expo. X1.000 Auto Paper Orig. Copy Finishing Cover Mixed Orig 1 RecallCancel 1134P360CA The Basic screen reappears with all the job settings made. If the job you have recalled is not what you e…