Minolta VECTIS 3000 Manual 

31, 58 59 TITLE IMPRINTING - Preselecting Titles Continued on following page. 4. Press and hold the title button for two seconds. • The last digit of the title code number will blink. 5. Press the adjust button to change its value. • Press and hold the adjust button to change the value rapi…

22, 40 41 SELECTING THE FLASH MODE FLASH RANGE The range of the built-in flash depends on the film speed and the focal length you are using. To ensure proper exposure, make sure your subject is positioned within the flash range. Press the flash-mode button until the desired indicator appears…

21, 38 39 PROCESSING USING THE BUILT-IN FLASH When you open the lens cover to turn the camera on, the built-in flash is set to Autoflash or Autoflash with red-eye reduction. The flash will fire automatically when necessary. For best results, take your film to a Certified Advanced Photo System ph…

14, 24 25 FULL-AUTO OPERATION 5. When the green ready lamp glows, press the shutter-release button all-the-way down to take the picture. • If the ready lamp does not glow, the flash is not charged. Wait until it glows, then take the picture. • If the ready lamp blinks quickly and the sh…

16, Minolta VECTIS 3000 28 29 FOR CLOSER SUBJECTS The green ready lamp will blink rapidly and the shutter will lock when you are closer than the minimum focus distance. The minimum focus distance of this camera is 40cm (1.3 ft.) when the print format is C or H. • When the print format is P, the minimum focus distance …

30, 56 57 TITLE IMPRINTING TITLE IMPRINTING - Preselecting Titles Three title codes have been set into memory. You can change one or all three title codes at any time. 1. Open the lens cover to turn the camera on. 2. Select the code for the title you want from the title list. Three titles from the ti…