Minolta magicolor 2210 Operation & User’s Manual

43, Minolta magicolor 2210 Loading Media 41 If you are printing duplex from the upper or optional tray, load the media print- ing-side down with the top of the media (or letterhead or memo information) toward the right side of the tray. If you are printing duplex from the multipur- pose tray, load the media pri…

169, Index 1.5° slant 75, 82 1200x1200 dpi printing 105 600x600 dpi printing 105 A Acc already disabled message 86 Acc disabled message 86 Acc enabled message 86 Acc file x% full message 86 Acc files got removed message 86 Accessories 5-bin mailbox 100 BuzzBox 100 CGM 100 Crown for DECnet-TC…

71, Solving Other Problems 69 Solving Other Problems Symptom Cause Solution Printer power is not on. The power cord is not correctly plugged into the outlet. Turn the power switch off (O position), then remove the power cord from the outlet and plug it back in. The mailbox power cord is no…

153, Repack the Printer151 Strapping/Buckling Instructions 1 Thread one end of the strapping through the wooden pallet. 2 Pull the two ends of the strapping together at the approximate center of the top of the printer. 3 Thread both ends up through the center of the buckle. 4 Weave …

127, SCSI Interface 125 Gently slide the controller board into the printer until it is fully seated, and then tighten the five screws. 6 Reconnect all interface cables. 7 Reconnect the power cord, and turn on the printer. 5" In compliance with UL guidelines, “The appliance inlet is …

36, Introduction34 Introduction This chapter provides information on handling, selecting, and storing media. Refer to the Maintenance Guide for media specifications. Media Handling Before purchasing a large quantity of special media, do a trial printing with the same media and che…