MINOLTA-QMS PagePro 4100W Operation & User’s Manual

135, 6 Troubleshooting 6-14 PagePro 4100W Tray 1 Paper Empty The paper supply of Tray 1 is empty. Add paper (see page 2-10 and see page 3-4). Tray 2 Paper Empty The paper supply of Tray 2 is empty. Add paper (see page 3-6). Tray 3 Paper Empty The paper supply of Tray 3 is empty. Size Mismatch The…

136, Troubleshooting 6 PagePro 4100W 6-15 Tray 2 No Cassette/ No Tray 2 The cassette for Tray 2 is not in place. Check the trays to make sure that all cassettes are securely in place (see page 2-23). A print job was sent using the Tray 2 setting in the printer driver, even though Tray 2 is …

97, 4 Printer Driver and Status Display 4-38 PagePro 4100W To Display the Driver Setup Dialog Under Windows NT 4.0 1 Click Start, point to Settings, and then click Printers to display the Printers dialog. 2 In the Printers dialog, click the Minolta/QMS PagePro 4100W icon. …

37, 2 Setting-up 2-22 PagePro 4100W 3 With one hand holding the duplex unit in position, use a Phillips screwdriver to tighten the screws that are permanently attached to the back of the duplex unit. NOTE Hold up the duplex unit with your hand during installation until it is secured to the pri…

14, Introduction 1 PagePro 4100W 1-9 When the Error LED is on LED Display Description Response Required Paper Size Error The paper-size setting of the printer driver does not match the size of paper that has been detected in the tray. Load the correct size of paper or cancel the print job (by pre…