MINOURA VFSG-9 Instruction Manual

8, MINOURA VFSG-9 6 The tire must be positioned in the center area of the drive roller (see Fig. L). If the tire is in contact or touching the other part of the resistance unit rather than the drive roller (see Fig. M), adjust the wheel position with the following steps; 1. Loosen the right side …

3, VFS-G (without remote shifter) VFS-G-R (with remote shifter) Fluid Unit Fluid Unit VFS-G Frame 35mm Rubber Foot Cap Sub Frame Sub Frame Back Plate Hub Handle Protector Cap Coupling Cover Hub Knob Bolt Coupling Tube (R) Coupling Tube (L) Unit Base Mount Base Pad Pad Cover Base Brac…

5, 4 M8x70 Bolt M8 Washer Base Bracket You can adjust the resistance unit position in 4 patterns to get the best tire contact to the drive roller for maximum performance. Wrong positioning may cause damage to the bearing and the unit housings. The best hole combination can be seen …

4, ASSEMBLE YOUR VFS-G TRAINER 1 M8x20 Bolt M8 Washer M8 Nylon Nut Assemble the Sub Frame onto the Main Frame: The metal Sub Frame Back Plate must be placed on the bottom of the Sub Frame as shown in Fig. A. Insert the M8 Nylon Nut into the hole on the backside of the Sub Frame. The nylon side mus…

6, PIVOT CAUTION The pivot between the Main Frame and the Sub Frame should be tightened rmly for easier installation of your bike onto VFS-G. The 6mm Hex Wrench is located in the L-shaped groove on the Sub Frame. Use this tool to tighten the pivot bolts. CAUTION: To much tightening may bre…