Diamond View DV156 Operation & User’s Manual

19, 18 No image is displayed, what can I do? ♦ Check that the light (LED) next to the monitor’s power button is lit and is green in colour. If the LED is green, press the Exit button on the monitor to access the On Screen Display. If the message NON PRESET MODE appears there, please…

21, Diamond View DV156 20 Input Signal Line Frequency 31.5 - 60.2 kHz multi-frequency Image Frequency (Refresh Rate) 56.3 - 75.0 Hz Within the parameters detailed in chapter 6 Video Signal RGB analog (Positive polarity) 0.7 Vpp/75 Ohm Synchronisation TTL separate, composite TTL Signal Connection 15-pin mini …

13, 12 • When you shut Windows down you may see interference lines on your screen. This caused by the manner in which Windows controls the graphics card at this point and is normal with all LCD monitors. • To extend the service life of the product, we recommend that you use your computer…

22, 21 1 1 1 1 Service Contacts If problems remain after checking this manual, please contact your place of purchase or contact: Australia Visit the Customer Support section of Mitsubishi Electric Australia’s web site at www.mitsubishi-electric.com.au for details of your nearest Mitsubishi Ele…

4, 3 1 1 Important Safety Instructions Please read the following safety instructions before installing or cleaning your Diamond View monitor: 1. Unplug the monitor’s power cable from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a soft cloth to clean th…