Monogram ZV850 Installation Instructions Manual

15, 15 Installation 36" Island Vent Hood • Remove protective film on filters. • Tip the filter into the lower slots at the rear of the opening. Lift the filter and pull the knob forward until the filter rests on the slots. • To remove the filters, grasp the knob, push the filter towards …

12, 12 Installation 36" Island Vent Hood Install Decorative Duct Covers Step 8 • Pretap or drive decorative screw into the screw holes on the support frame. This will make screw installation easier. • Separate the two decorative duct covers. • Select the inside (top) cover, which ha…

7, Monogram ZV850 7 Installation Preparation 36" Island Vent Hood Advance Planning 1 Step Note: The cross framing must be spaced 8-3/4” on the side from centerline to centerline in order to accept the hood mounting screws. Plan the location Determine the exact location of the vent hood. • Use a p…

2, Before you begin – Read these instructions completely and carefully. IMPORTANT – Save these instructions for local inspector’s use. IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES. Note to Installer – Be sure to leave these instructions with the Consumer. Note to Consumer – …

4, 4 Design Information 36" Island Vent Hood A duct cover accessory is required for all ceiling heights. Use this chart to determine the correct Duct Cover Accessory for 8 ft. to 10 ft. ceilings that must be ordered with the hood. Using Duct Cover Accessories A B 15-3/4" 9-7/16&qu…