MSC COM EXPRESS CX-MB-EVA2 Operation & User’s Manual

21, CX-MB-EVA2 User's Manual Hardware 21 4.3 PCI Express x1 Slots One PCIe x1 slot is assigned to each of the 6 PCIe lanes of the COM Express module. Note: The order of the connectors has changed on the new layout. Now X6 is near PEG slot. Note : The number of PCIe lanes available …

34, CX-MB-EVA2 User's Manual Hardware 34 4.13 Ethernet The base board can be connected to a local area network with an Ethernet interface. The COM Express module already provides MDI signals, so that only the transformer on the base board required. The transformer PULSE H 5004 …

11, MSC COM EXPRESS CX-MB-EVA2 CX-MB-EVA2 User's Manual Introduction 11 LCD JILI40 JILI JILI EEPROM BACK LIGHT PCI e Graphics VGA TVout Line IN Line OUT MIC Head Phone AC97 - CODEC GPIO EEPROM LAN Trans - former Super IO PS/2 COM1 COM2 IrDa HW Mon…

19, CX-MB-EVA2 User's Manual Hardware 19 4.2 PCI Slots Four 32-bit PCI slots are provided according to PCI specification v2.1. The signal assignment for slot 0, slot 1, slot 2 and slot 3 is defined in the COM Express specification.  INTA#, INTB#, INTC# and INTD#  REQ[0..…

26, CX-MB-EVA2 User's Manual Hardware 26 4.6.2 Backlight Inverter Interface The supply voltage of the backlight can be adjusted with jumper JP0601. The according position is printed on the PCB. Jumper J5 should be set according to the backlight inverter used. If th…

32, CX-MB-EVA2 User's Manual Hardware 32 4.10.1.1.3 Compact Flash Interface A socket for compact flash cards, type I/II, is provided at the primary IDE channel. The compact flash interface supports True IDE mode according to compact flash specification rev. 3.0. Inter …