NAD C316BEE Owner's Manual

6, IDENTIFICATION OF CONTROLS FRONT PANEL 1 STANDBY: With the rear panel POWER switch set to ON position, press this button to switch ON the C 316BEE from standby mode. The Standby LED indicator will turn from amber to blue. Pressing the STANDBY button again turns the unit back to st…

12, www.NADelectronics.com ©2010 NAD ELECTRONICS INTERNATIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International C 316BEE Owner’s Manual …

7, 7 TONE CONTROLS: The NAD C 316BEE is tted with BASS and TREBLE tone controls to adjust the tonal balance of your system. The 12 o’clock position is “at” with no boost or cut, and an indent indicates this position. Rotate the control clockwise to increase the amount of …

11, NAD C316BEE LINE LEVEL INPUT Input impedance (R and C) 50kΩ + 100pF Input sensitivity (ref. rated power) 200mV Maximum input signal 7V LINE LEVEL OUTPUT Output impedance Tape Source Z + 600Ω Treble ±5dB at 10kHz Bass ±8dB at 100Hz Continuous output power into 8Ω 1…

9, USING THE AMP 1 REMOTE CONTROL The AMP 1 remote control handset handles the key functions of the C 316BEE. It has additional controls to remotely operate NAD CD Players. It will operate up to a distance of 23ft (7m). When a command from the remote control is received, the Standby LED indicator…

4, NOTES ON ENVIRONMENTAL PROTECTION At the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s manual and packagi…