Specifications:572/572007-582mcl047.pdf file (21 Oct 2023)
|
Navitar 582MCL047 Projector Accessories PDF Installation Instructions (Updated: Saturday 21st of October 2023 11:35:55 AM)
Rating: 4.9 (rated by 81 users)
Compatible devices: 682MCL012, 586MCL047, 490MCL1625, 643MCL1028, 633MCZ087, 484MCZ500, 651MCL1028, 850MCL012.
Recommended Documentation:
Installation of Navitar/NuView Series 582 lens on Shapr XG-PH50X & PX70X Projectors. TOOLS REQUIRED: Phillips head screwdriver Disassembly: 1. Disconnect unit from power source. Remove one (1) Phillips head screw from the center-back of the lamp cover on top of the unit. Remove the lamp cover and set aside. Remove two (2) Phillips head screws from the unit cover behind the lamps and remove the cover by lifting the back and sliding it forward. Set the cover aside. 2. A plastic lens ring is attached to the lens and may be removed by simply applying pressure to unsnap it from the lens. Also, a circular cowl rests on the lower cover and it must be removed. Neither of these items will be reinstalled. 3. The prime lens is attached via three (3) Phillips head screws. Locate these screws and remove them. Before removing the lens the wires must be disconnected via the simple connector above the lens. Assembly: 1. If you are installing a Navitar MCZ275 and MCL047, the adapter is an integral lens component and you will use the three (3) screws provided with your Navitar lens to attach the lens to the projector. This lens is now installed and the projector cover and lamp cover may now be reinstalled. To adjust the zoom and focus, twist the knurled inner ring to zoom and the knurled outer ring to focus the lens. 2. All other lenses (MCL1028, MCZ500, MCZ900) use an adapter that may be removed from the lens. Remove the adapter from the lens and install it on the projector using the three (3) screws provided with your Navitar lens. 3. Install the Navitar lens into the adapter by gently turning it clockwise into the lens mount. The lens should now be properly installed. 4. To focus, gently twist front of lens. To zoom, loosen the thumbscrew and twist knurled ring but ensure you re-tighten the thumbscrew. CAUTION: Do not twist entire lens out of mounting bracket! REV 09/15/05 PB
Billion Modem Manual (#35556R)
702AE, 2, billion/702ae.pdf
KL-650-THX Speakers - #BS76U6
KL-650-THX, 28, klipsch/kl-650-thx.pdf
5005 IP Phone - #JA2WBU
5005, 28, mitel/5005.pdf
Motherboard GA-8IRM User Guide, #I7875H
GA-8IRM, 47, gigabyte/ga-8irm.pdf
#12WTMN: Solar Controller Kit Handbook
Solar Controller Kit, 12, rheem/solar-controller-kit.pdf
Tesla Power Supply Manual (#TZ53CH)
TI50A, 37, tesla/ti50a.pdf
Indoor Fireplace Direct Vent HDV500 Reference Book, #WLI111
Direct Vent HDV500, 2, monessen-hearth/direct-vent-hdv500.pdf
Parrot User Manual: CK3000 (#R4KZRL)
CK3000, 48, parrot/ck3000.pdf
Nady Systems Microphone Manual (#2HATN2)
IRW-2PA, 8, nady-systems/irw-2pa.pdf
Harman Kardon DVD Player Manual (#398TLN)
50, 2, harman-kardon/50.pdf
1 Quick Installation Guide for wivia 3 For version 3.2.0.0 – Mar. 16th, 2015 1. Installation 1. Connect two of antennas to the device. 2. Connect wivia and the display with VGA or HDMI cable. * Connect the device and the audio speaker with the audio cable when you use audio, whe ...
Model & Doc Type: Wivia 3 6
7N8P7263Printed in China©NEC Display Solutions, Ltd. 2006-2007Ver. 3 04/07 (T)1 Connect the supplied power cable. Schließen Sie das mitgelieferte Netzkabel an. Connecter le câble d'alimentation fourni. Collegate il cavo d´alimentazione in dotazione. Conecte el cable de alimentaci ...
Model & Doc Type: VT49 2
Installation of Navitar/NuView Series 638 lens on Sony model VPL-PX35, PX40 & PX41 Projectors. TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVER Disassembly: 1. Disconnect the unit from the power source and place projector with the bottom facing upwards. Remove one (1) screw from the rear-cent ...
Model & Doc Type: 638MCZ087 1
LP650 Lamp Replacement Instructions Use the chart below to interpret the LED messages. 1 Turn off the projector. 2 Unplug the power cord. 3 Allow the projector to cool for 60 minutes. 4 Remove the two screws that fasten the lamp door to the bottom of the projector. 5 Lift the lamp door up and ...
Model & Doc Type: LP650 2
# | Brand | Model | Document Type/File | Pages | File Size | Last Checked |
---|---|---|---|---|---|---|
1 | Cisco | TelePresence System Codec C20 |
127 | 11/04 | ||
2 | Vivo | MOUNT-VP05W |
8 | 15/03 | ||
3 | Premier Mounts | Nova-EXT |
16 | 06/03 | ||
4 | CHIEF | SL-236 |
8 | 0.41 Mb | 10/12 | |
5 | CHIEF | SL-236 |
4 | 13/12 | ||
6 | Epson | PowerLite 450W |
4 | 2.17 Mb | 15/11 | |
7 | Biamp | Modena Hub |
4 | 16/04 | ||
8 | Vivo | PS-T-084 |
3 | 22/02 | ||
9 | Cisco | SX80 |
24 | 05/01 | ||
10 | CHIEF | RSA |
19 | 1.78 Mb | 27/10 |
# | Brand | Model | Document (PDF) | Pages | Size | Check Date |
---|---|---|---|---|---|---|
1 | Linear | DC266B-A |
6 | 20.03.2024 | ||
2 | d&b audiotechnik | E6530 |
14 | 15.02.2024 | ||
3 | Tripp Lite | B032-VUA2 |
44 | 03.11.2023 | ||
4 | Palsonic | TFTV100A |
1 | 0.25 Mb | 18.01.2024 | |
5 | Dorel | B34554419600 |
15 | 30.11.2023 | ||
6 | Polycom | SoundPoint IP 650 |
112 | 10.10.2023 | ||
7 | Ricoh | Caplio RR-10 |
2 | 1.62 Mb | 03.11.2023 | |
8 | Karcher | KARCHER K 5.85 M |
12 | 29.10.2023 | ||
9 | Titan | SPEEFLO PowrTex 6900 SF |
36 | 02.04.2024 | ||
10 | Arcam | fmj AVR360 |
55 | 4.52 Mb | 04.12.2023 |