Navman M300 Operation & User’s Manual

10, Navman M300 M300 1-10 NAVMAN M300 - Getting started 3.3.1 Enter setup To enter setup Press and hold to turn the power on and enter setup. When the counter reaches zero, the M300 will enter setup. If you release before the counter reaches zero the M300 will immediately start normal operation…

13, M300 1-13 NAVMAN M300 - Setup 4.1.3 Beep Set beep ON or beep OFF. When beep is ON, an audible ‘beep’ will sound when buttons are pressed. Access this option If necessary, press and hold to turn the power on and enter setup. Press repeatedly until the screen appears as shown abov…

5, M300 1-5 NAVMAN Content M300 - Content 1.0 General information 1-6 1.1 Checklist 1-6 1.2 Care and maintenance 1-6 1.3 Water resistance 1-6 1.4 Changing the battery 1-7 2.0 Navman M300 interface 1-8 2.1 Button functions 1-8 2.2 Display screen 1-8 3.0 Getting started 1-9 3.1 Be outdoors 1-…

9, M300 1-9 NAVMAN M300 - Getting started 3.1 Be outdoors The M300 is not intended for operation indoors or under water as it uses Global Positioning System (GPS) satellites to get time and date information, and to calculate distance and speed. For best results, always use the M300 outdoors with an …

20, M300 1-20 NAVMAN M300 - Normal operation 5.1.6 Clock mode Clock mode shows the current time and date. (Time is only displayed while GPS satellite signals are available. By default, GPS time is displayed. See section 4.1.5 for instructions on setting local time.) Access this mode If…

12, M300 1-12 NAVMAN M300 - Setup 4.1.1 Set time format Set 12hr or 24hr time display format. To access this option If necessary, press and hold to turn the power on and enter setup. Press repeatedly until the screen appears as shown above. To set time format 1) Press to start editing (…