Network Technologies UNIMUX series Installation And Operation Manual

26, NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH 21 User Login User Login Mode requires a user to login with a user name and password from the list created by the administrator. The user will only be able to login if security is enabled. With security enabled, …

15, NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH 10 Limitations • Only one non-HID (Human Interface Device) can be connected at a time (device other than keyboard or mouse) • A USB hub (single or multi-port) can be used provided only USB input devices are plugged into it.…

47, NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH 42 UPGRADE PROCEDURES Start the Bootloader In the HyperTerminal window on the attached computer, press and hold the <Tab> key and power ON the UNIMUX. The following message (or one similar) will be displayed on the scr…

4, Network Technologies UNIMUX series iii Alternate Command Hot Key ........................................................................................................................ 26 Reset Port names ............................................................................…

50, NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH 45 Read the Checksum of HID or Vendor Specific Port Controller Firmware Reading firmware checksum is useful to determine the version of software running on port controllers. While the firmware revision for user controller can be found on …

33, NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH 28 Serial Baud Rate The serial baud rate for the UNIMUX can be changed by pressing <B> from the System Configuration menu. In order to control the UNIMUX via RS232 (page 31), the baud rate must be set the same as t…