Northern 82XTC Owner's Manual

55, Operation Description 49 2.19.3 Power Output Shaft (PTO) Break-in The engine throttle control handle should be set in the medium position and the engine should be run at medium speed. Turn the power output shaft on so that it runs at low speed and high speed respective for 5 m…

43, Operation Instruction 37 2.16.7 Sway Bar Adjustment The sway bars are mainly used to prevent impact on the rear wheels of the tractor caused by an overlarge swing of the lower tie rod when the tractor turns around at the end of a field with a lifted farm implement in tow. W…

48, Operation Instruction 42 2.17 Tractor Upper Chassis The tractor upper chassis includes the following: the hood, the cab (optional), the fenders, the instrument console, the driver’s seat, the floor mats, and various attachments. 2.17.1 Tractor Hood The tractor hood is made of str…

67, Northern 82XTC Operation Description 61 2.20.8 Starter Faults and Troubleshooting Table 2-12 Starter System Faults and Troubleshooting Fault Causes Solutions Starter does not turn over (1) Battery capacity is insufficient (2) Battery terminal is dirty (3) Cable connection is …

72, Accessories and Consumables 66 3.1.5 Air Conditioner The air conditioner is located between the headliner of the cab roof cab roof panel. Air conditioner controls are located on the left side of the headliner, above the driver. Air supply vents for the AC unit are also in the …

18, Safety Precautions 12 Hazards increase with shafts that are not round. Clothing is more likely to catch if there is dried mud or manure on the shaft, or if the shaft is nicked. Ends of shafts that protrude beyond bearings are also dangerous. Universal joints, keys and fastening devic…