Nuheat Solo Operation & User’s Manual

6, SOLO 400-632-000-A 2008-09-19 6/7 NOTE: The Select button flashes during the error display when there is corrective action to be taken. Also, the appropriate wording flashes on the screen to pinpoint the source of the problem. All programmed se…

1, Nuheat Solo SOLO 400-632-000-A 2008-09-19 1/7 The SOLO thermostat is designed to control the temperature of a floor heating system for both 120-volt and 240-volt applications. The thermostat can be used to control either the floor temperature or the ambien…

5, SOLO 400-632-000-A 2008-09-19 5/7 5.3 Early Start Early Start calculates the optimal time to start heating in order to obtain the desired temperature by the set time. It applies only if your thermostat is following a programmed schedule (i.e. …

3, SOLO 400-632-000-A 2008-09-19 3/7 3.3 Setting the Workday Schedule The default workday schedule (Table 3) represents a typical workday. Table 3 To modify the Workday schedule: n Press and hold the Select button for 2 seconds to enter the Progr…

2, SOLO 400-632-000-A 2008-09-19 2/7 s Reinstall the thermostat faceplate on its base and secure it with the screw. If there is a sticker on the screen, peel it off. t Apply power to the heating system. Verify the installation by making sure that the …

7, SOLO 400-632-000-A 2008-09-19 7/7 The Honeywell outdoor sensor AC629 allows the thermostat to display the exterior temperature and humidity readings (refer to section 4.3). To connect the sensor: n Insert one end of a pair of AWG 18 wires through one of…