Oakton 35629-20 Instruction Manual

10, English 10 Distance & Spot Size As the distance (D) from the object increases, the spot size (S) of the area measured by the unit becomes larger. The rela- tionship between distance and spot size for each unit is listed below. The focal point for each unit is 914mm (36”). The spot size…

14, English 14 Recalling Data To recall stored data after the unit shuts off, press the MODE button (3) until LOG appears in the lower left corner (E). A LOG location number will be shown below LOG, and the stored temperature for that location will be shown in the lower right corner of the display (D).…

9, Oakton 35629-20 English 9 English How to Accurately Measure Temperature Locating a Hot or Cold Spot To find a hot or cold spot, aim the thermome- ter outside the area of interest. Then slowly scan across the area with an up and down motion until you locate the hot or cold spot. Field of View Make…

7, English 7 How it Works Infrared thermometers measure the sur- face temperature of an opaque object. The unit’s optics sense emitted, reflect- ed, and transmitted energy, which are collected and focused onto a detector. The unit’s electronics translate the information into a temperat…

12, English 12 Setting the High Alarm and Low Alarm To set values for the High Alarm (HAL) and Low Alarm (LAL), pull the trigger. While holding the trigger, press the MODE button (3) until the appropriate code appears in the lower left corner of the display (E). Use the up and down keys…

13, English 13 Storing Data Your thermometer is capable of storing up to 12 data locations. The infrared temperature, temperature scale (°C or °F), and emissivity are also stored. Infrared To store data from an infrared reading, pull the trigger. While holding the trigger, press the…