ParaBody 445103 Assembly Instructions Manual

2, NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THI~ HEAD OF THE BOLT. Iliiiii!!1 BOLT LENGTH BOLT LENGTH RULER: 2 4 5 6 [IMPORTANT NOTES[ WELCOME TO THE WORLD OF Seeiou~ Please note: * Thank you for purchasing the Parabody 445103 Second Stack Option. Please read these instructions …

3, I 2 3 4 5 6 8 9 PART# DESCRrPT~Or~ 6523401 GUIDE ROD 6266001 WEIGHT STACK SHAFT ’" 6375902 1-i/4 SQ. X 4-7/8 ~E 671~601 ~ PLA~BLA~ 6747501 P~SS-S~ACK ~LE 3’116101 4~’i/~" P~LEY *h~4o~ SVA~e~ 3108002 ~IG~ STA~ COSmON 3117401 C~ PLUG PARTS LIST 2 10 2 12 1 16 2 …

13, FIGURE 17 STEP 17 If the 435103 LEG PRESS ADAPTER KIT is not installed the rear SHROUD opening must be removed. AI~ply pressure to the bottom of the SHROUD where the "V" groove is and carefuly remove the weight stack opening on the plastic SHROUD as show~.…

10, X 1-114" FIGURE 13 BASE ;TEP 13 ¯ Insert four CAP PLUGS (9) into the top and bottom ends of the GUIDE RODS (1) as shown in FIGURE13. ¯ SECURELY assemble the WEIGHT STACK SHAFT (2) to the I-[EAD PLATE (4) using one 3/8 X 1-1/4" BOLT (14) and one WAS…

4, PLATE CABLE FIGURE 3 STEP 3 ¯ Unscrew the threaded ends of the HEAD PLATE CABLE from the WEIGHT STACK SHAFT & the D-RING and remove HEAD PLATE CABLE. The HEAD PLATE CABLE will be used later. See FIGURE 3. (NOTE: Remove pulleys for ease of removal.) …

12, ParaBody 445103 STEP 15 ~) ¯ Screw one of the threaded ends of the previously removed HEAD PLATE CABLE approximately I" into the end of the WEIGHT STACK SHAFT. See FIGURE 15. FIGURE 15 HEAD PLATE CABLE (67250) STEP 16 ¯ Route the thread end of HEAD PLATE CABLE up and over the PULLEYS…