Optoma EP752 Manual 

33, 33 English User Controls Setup Projection  Front-Desktop The factory default setting.  Rear-Desktop When you select this function, the projector reverses the image so you can project behind a translucent screen.  Front-Ceiling When you select this fu…

3, 3 English Usage Notice  When the lamp reaches the end of its life, the projector will not turn back on until the lamp module has been replaced. To replace the lamp, follow the procedures listed under “Replacing the Lamp” section on pages 47-48. Precautions Pl…

6, 6 English Introduction Product Features This product is a XGA single chip 0.55” DLP ® projector. Outstanding features include:  True XGA, 1024 x 768 addressable pixels  Texas Instruments Single chip DLP ® Technology  NTSC/NTSC4.43/PAL/PAL-M/PAL-N/SECAM and …

48, Optoma EP752 48 English Appendices Lamp Replacement Procedure: 1. Switch off the power to the projector by pressing the “Power/Standby” button. 2. Allow the projector to cool down for at least 30 minutes. 3. Disconnect the power cord. 4. Press down and then pull the cover carefully.  5. Open…

19, 19 English Installation Adjusting the Projector’s Zoom / Focus Adjusting Projection Image Size You may turn the zoom lever to zoom in or out. To focus the image, rotate the focus ring until the image is clear. The projector will focus at distances from 3.9 to 39.4 feet (1.2 to 12.0 meter…

13, 13 English Installation Connect to Computer/Notebook/VGA-In  Due to the difference in applications for each country, some regions may have different accessories. 1.............................................................................................................…