Oricom UHF300 Operation & User’s Manual

22, 22 UHF channels and frequencies EMC Technologies (NZ) Ltd Test Report No 101127.1 Report date: 25 th November 2010 6.2 Nominal Carrier Table 1 Nominal Carrier Frequency Channel Tx Rx Channel Tx Rx Freq Freq Freq Freq MHZ MHz MHz MHz 01* 476.4250 476.4250 21 476.9250 476.9250 4…

20, 20 Operations Transmitting NOTE: Before transmitting on any channel, listen to check the channel is not already in use. Transmitting Select the desired channel. Press and hold the PTT button on the microphone and speak normally into the microphone. Hold it approx. 7cm from your mo…

23, 23 UHF channels and frequencies 38 CTCSS CODE LIST CODE Frequency(Hz) CODE Frequency(Hz) OFF OFF 20 131.8 1 67.0 21 136.5 2 71.9 22 141.3 3 74.4 23 146.2 4 77.0 24 151.4 5 79.7 25 156.7 6 82.5 26 162.2 7 85.4 27 167.9 8 88.5 28 173.8 9 91.5 29 179.9 10 94.8 30 186.2 11 97.4 …

15, Oricom UHF300 15 Operations The Repeator Access function can be set (from channel 1 to 8 and 41 to 48) used by local repeater stations. When activated, your radio will receive the Repeator on its specific channel (all repeater outputs are on channel 1 to 8 and 41 to 48) but transmit to the repeater channel …

2, This unit complies with all relevant Australian and New Zealand approval requirements AS/NZS 4365:2011 Why has the ACMA increased the number of available UHF CB channels? To provide additional channel capacity within the UHF CB Band the ACMA will over the next 5 years change the majority of…

16, 16 Operations Open Scan (OS) Mode The Open Scan feature scans for activity on all CB channels. Once a channel is located, scanning will pause the will allow the signal to be heard. As soon as the channel is clear and scan delay time has expired, scanning will continue automatically…