Perle IOLAN SDS Reference Manual

87, Line Commands 87 Line Service Commands Set Vmodem both|in|out|none The direction in which information is received or relayed: z None—UDP service not enabled. z In—LAN to serial. The IOLAN will listen on port value configured in the DS Port parameter for messages coming from the…

90, Perle IOLAN SDS Line Service Commands 90 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7 Set Vmodem-Phone Set SSL Line Description This command associates a phone number with an IP address and TCP port. This enables the existing modem application to issue a dial command with a phone number. The pho…

69, Line Commands 69 Line Commands break Specifies how a break is interpreted: z off—The IOLAN ignores the break key completely and it is not passed through to the host. This is the default setting. z local—The IOLAN deals with the break locally. If the user is in a session, the break key …

1, IOLAN SDS/SCS/STS/MDC Command Line Interface Reference Guide Version 3.7 Part #5500210-14 December 2008 …

82, Line Service Commands 82 IOLAN SDS/SCS/STS/MDC CLI Reference Guide, Version 3.7 ipaddr-neg Specifies whether or not IP address negotiation will take place. IP address negotiation is where the IOLAN allows the remote end to specify its IP address. The default value is Off. When On, the IP a…

109, Network Commands 109 Gateway Commands Gateway Commands Add Gateway Description Adds a gateway. You can configure up to twenty gateways. User Level Admin Syntax add gateway <config_host> default add gateway <config_host> host <dest_IP_addr> add gateway <config…