Planar Dome E4c Quick Reference Manual

7, 7 Connecting the Display To connect the display 1 Connect the DVI cable to either port of the installed controller board. NOTE: The AX5 board provides dual-head functionality: You can run two Dome E4c displays from one AX5 board. Both DVI ports provide dual- link function…

4, 4 Display Components The LED on the display front indicates display status. Green, the display is connected and running properly. Amber, the video signal is not being received. The integrated video cable and input power port are located on the back. NOTE: You can connect the vid…

3, 3 Check the contents of your Dome E4c display package for all the items shown here. Save the original packaging materials for storage and shipping. IMPORTANT: Read “Handling the Display” on page 10 before you set up the display. Unpacking the Display Software CDsPower cord Graphics card Powe…

10, 10 Handling the Display • Set up your display on a stable, level surface away from any direct light or heat source, but near a grounded AC outlet. • Choose a well-ventilated location with an adequate amount of space. Do not block the vents on the back of the display. • Neve…

11, Planar Dome E4c 11 Regulatory Compliance This display has been tested and found to comply with IEC/EN 60601-1 and IEC/EN 60601-1-2 standards, and is certi ed to meet medical standard C22.2 No. 601.1-M90 (C US Mark). The medical display, in addition to meeting medical requirements, has been tested and found to…

6, 6 Installing the Display Controller To install the controller 1 Turn o your computer and all peripherals. Disconnect all cables from your computer. Leave the power cord plugged into the grounded outlet. 2 Remove the computer cover. 3 Remove any existing graphics card and video sig…