Planar E2 Reference Manual

9, 9 To change video setting per display 1 Click the PowerDesk icon on the taskbar. 2 On the PowerDesk menu, select the controller representing the display you want to change video settings on, then select Grayscale Setup category. NOTE: Grayscale mode is the installation default. …

4, 4 Display Components Reset button. Restores the display con guration to its default setting. LED status lights. Provides information about the status of the display. DIN connector. Drives power to the display; 4-pin connector on the Dome E2 display, 8-pin connector on …

7, Planar E2 7 Installing the Display Driver Before you install the driver, remove any previously installed display driver for the controller from your system. To install the driver 1 Start your computer system. Log on with administrator privileges. 2 Click Cancel on the Found New Hardware …

3, 3 Unpacking the Display Check the contents of your Dome EX display package for all the items shown here. Save the original packaging materials for storage and shipping. Guidelines • Use both hands to lift or adjust the display. • Avoid touching the display screen. • Do not set up the …

8, 8 Adjusting Display Properties To set brightness You must have the Dome CXtra software installed to change the display brightness. Adjust the value of the white level on the Backlight tab of the RightLight Panel Con guration. To rotate the display 1 Click the PowerDesk icon on the taskbar. 2 …