PlaySafe Middleton Swing Set Owner's Manual And Assembly Instruction

9, 5 Once fully assembled, check that the glider swings freely. If it does not, make sure that the bolts holding the vertical poles to the top bar attachment are not overly tightened. Part Ref. #: PSHW21, PSHW36 SEE-SAW ASSEMBLY Required Parts: See-S…

2, 2 © 2006 Pacific Cycle, Inc. To make claim under warranty, notification of such defect must be given to Pacific Cycle, Inc. By calling the phone number below, you will be instructed on how the product or part needing replacement should be shi…

6, PlaySafe Middleton Swing Set MAIN FRAME ASSEMBLY Required Parts: Top Bar x2 Leg x6 Support Bar x3 Corner Fitting x2 Center Fitting x1 Pre-Assembled Parts: • Swing and trapeze hooks should be in place on the top tube. • Hardware for legs should be in place in the corne…

7, 4 Remove the hardware from the corner fitting prongs. Align the two sets of holes for each leg and replace the hardware through the corner fitting prongs to secure the legs. Do not over tighten the screws. After all parts are assembled you will need to tighten again. Part Ref…

11, 2 Check the nut and bolt on the swing seat to make sure that they are secure. Part Ref. #: PSSH11, PSHW13 LAWN SWING ASSEMBLY Required Parts: Lawn Swing Attachment x2, Vertical Pole x4, Foot Plate x2, U-Shaped Hand Rail x4, Seat Support Bar x8, Seat/Backrest x4 …

13, 8 Lay the seat over the seat support bars. Using the hardware provided on the U- shaped hand rails, attach the seats and seat support bars to the U-shaped hand rail. Part Ref. # PSHW17 9 Using the hardware provided on the U- shaped hand rails, attach the seat su…