Portwell ROBO-6710 Operation & User’s Manual

58, Trouble Shooting ROBO-6710/6730VLA User’s Manual 5-2 Figure 5-2 Step 2: And then use 4-pin power cable to connect both ATX P/S Control Connector on backplane and 5VSB Header For ATX (J20) on Signal Board Computer. (Figure 5-3) Figure 5-3 Step 3: Please adjust A…

6, System Overview ROBO-6710/6730VLA User’s Manual 1-2 1.2 Check List The ROBO-6710/6730 series package should cover the following basic items:  One ROBO-6710/6730 single board computer  One CPU cooler (ROBO-6710); one CPU heat sink (ROBO-6710)  One Parallel port &a…

9, Portwell ROBO-6710 System Overview ROBO-6710/6730VLA User’s Manual 1-5 1.3.1 Mechanical Drawing 19.5 27.09 8.26 143.40 186.78 41 3.5 13.72 100.33 3- Pad 7 4- HOLE 3.3 4- Pad 7 41 3- HOLE 4 3.9 178 3.5 1.4 System Architecture The following illustration of block diagram will show you…

60, Trouble Shooting ROBO-6710/6730VLA User’s Manual 5-4 AT Power Setting This section will introduce you how to quickly and appropriately set up AT power on your system. Step 1: If you were currently using ATX mode, please remove 4 pins power cable from the 5VSB Header For ATX and from…

24, System Installation ROBO-6710/6730VLA User’s Manual 3-3 1. The notch in the module fits into a key in the slot 2. Hold the module at a 45-degree angle to the slot and slide it into place. 3. Module should lay flat against the SBC Notes: (1) To maintain system stability, do not ch…

32, BIOS Setup Information ROBO-6710/6730VLA User’s Manual 4-3 4.3 Standard CMOS Setup Menu This setup page includes all the items in standard compatible BIOS. Use the arrow keys to highlight the item and then use the <PgUp>/<PgDn> or <+>/<-> keys to …