Powermatic 3-Roll Powered Stock Feeder PF3-JR Operating Instructions Manual

4, Powermatic 3-Roll Powered Stock Feeder PF3-JR 4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they …

10, 10 6. Place the base over the hole pattern. Ali g n the four holes of the base with the holes in the mounting surface. Make sure the lock handle is positioned in a convenient place before tightening the base to the mounting surface. 7. Insert four M10 screws (not provided) through the hol…

9, 9 Assembly and Installation Tools needed for assembly: 5mm hex wrench 12mm and 14mm open end wrenches Remove the clear plastic from around the feeder and stand. Exposed metal surfaces have been given a protective coating at the factory. This should be removed with a soft cloth m…

2, 2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Autho…

22, 22 Parts List: PF3-JR Stock Feeder Index No. Part No. Description Size Qty 1 .............. PF3JR-201 ..............Oil Cap .............................................................................................. 1 2 .............. PF3JR-202 ..............“O” Ring…

13, 13 3. Loosen lock handle ( B, Fi g ure 10 ) and rotate the swivel cone (C, Figure 10) 180- degrees, as shown in Figure 10. 4. Re-tighten lock handle (B, Figure 10). 5. Loosen lock handle (D, Figure 10) and rotate the arm cone as needed until it can slide back onto…