Printronix P5 Quick Setup Manual

25, 25 Interface Connections Interface Connections Figure 21. Standard Interfaces NOTE: Centronics is not present on Network-based models. 55auxios Jul y 14, 1999 Dataproducts Standard Adapter Serial RS-232/RS-422 Auxiliary I/O Diagnostic Pedestal Models Centronics, Ethernet Centronics Ether…

38, Printronix P5 Install Optional Components 38 Figure 35. Power Stacker Components 4. Make sure the wire paper tent is fitted in the pull out paper tray in the base of the stacker. Wire Paper Tent Paper Stacker Rails …

17, 17 Remove The Tags Pedestal Models Figure 13. Removing the Tie Wrap from the Pedestal Model 3. Remove the tie wrap attached to the output basket. It is marked with a large, red tag. Tie Wrap Red Tag Output Basket …

22, Connect The Interface And Power Cables 22 Figure 18. Interface and Power Locations 4. Open the cabinet rear door, and remove the I/O cover from the selected I/O connector. 5. Locate the cable routing notch in the lower left corner of the back of the cabinet. I/O Cover Cable-Routing…

42, Install Optional Components 42 Quick Access Cover (Pedestal Models) Figure 39. The Quick Access Cover on the Pedestal Model Figure 40. Paper Exit Options If your pedestal model is equipped with the quick access cover, you may choose how the paper exits the printer. Pushing the lever …